ASSEMBLY
11
ASSEMBLY
WARNING
!
Do not attempt to assemble or operate this pressure washer until you have readand
understood this entire manual. If you have any problems assembling or operating this
unit
WARNING
!
Do not operate this pressure washer if any of the parts are damaged or missing until
the part is replaced. Using this product with damaged or missing parts can cause
damage to the machine or result in serious injury or death.
Unpacking
1. Remove the product, parts, and all accessories. Make sure all items listed on the packing list are included
and not
damaged.
Foot and wheel assembly
-
Raise or tilt pressure washer so you can line up foot with the hole located at the center of the frame.
-
Align the rubber foot with the hole in the frame where the foot is to be located. Attach foot by inserting the bolt from
the bottom up and install the acorn nut. Wrench tightens until there is a slight crush on the frame tube (Do not over
tighten).
-
Pass the axle through the wheel, and then through the wheel bracket. Use the R pin to lock the wheel.
Summary of Contents for FNHPT240
Page 22: ...22 WIRING DIAGRAM...
