ORIGINAL INSTRUCTIONS > EN
Felt wheel pointed
4000~20000
3
Flap wheel
4000~20000
3
HSS cutters
9000~35000
6
Drill bits
4500~35000
6
Brush
4000~15000
2
L pin
N/A
To switch on, push the ON/OFF switch to “I” position.
To switch off, push the ON/OFF button to the “0” position.
9. CLEANING AND MAINTENANCE
9.1 MAINTENANCE
Always disconnect the device before performing any adjustment or maintenance operation.
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
If the carbon brushes need to be replaced, have this done by a qualified repair person (always replace the
two brushes at the same time).
Regularly inspect the accessory, ensure the accessories are free of crack and surface defects. Replace the
accessory when it has worn out.
If the supply cord of this power tool is damaged, it must be replaced by a specially prepared cord available
through the service organization
9.2 CLEANING
This tool does not require any special maintenance. Regularly clean the ventilation slots. Avoid using
solvents when cleaning plastic parts. Most plastic parts are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.
9.3 LUBRICATION
All the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the
unit under normal operating conditions; therefore no further lubrication is required.
9.4 STORAGE
Place the tool and all the accessories on the box. The box shall be stored in a dry place, out of reach of
children
.
14
