ORIGINAL INSTRUCTIONS > EN
when using polishing and brushing accessories.
For milling or engraving hold the tool like a pen, and keep the ventilation slots clear. For heavier work
hold the tool like a hammer.
For cutting disks hold the tool in both hands and use high speeds. This accessory is brittle and should
only be used for straight cuts. Do not sand or curved holes.
If the tool slows down or over-heats you may be applying too much pressure.
The tool is most effective with clean sharp tools. If more pressure is needed try cleaning or replacing the
accessory.
Some accessories are brittle. Use the tools speed and not pressure to do the work.
It is recommended it is run for 15 minutes of normal use. The tools should then be allowed to cool for 30
minutes. Heavy use may give less than 15 minutes continuous use.
The mini grinder has a variable speed control mechanism designed to allow the operator control and
adjustment of speed. The speed can be increased or decreased by the rotation of speed selector.
Picture
Name
Suggested
working
speed
Max speed
level
Grinding Stones with shank
9000~35000
6
Diamond bit
18000~35000
6
Collet
N/A
Sanding bands
4500~26000
4
Mandrel for cut-off wheel
N/A
Mandrel for felt wheel
N/A
Sanding shanks
N/A
Grinding wheels
9000~35000
6
Whet stone
N/A
Cut off wheels fiberglass
4500~35000
6
Rubber emery wheel
4500~11000
1
Wrench
N/A
Polishing compound
N/A
Cut off wheels
4500~35000
6
Sanding paper
4500~20000
3
Felt wheels
4000~20000
3
13
