Feider Machines FM2030-1, Instruction Manual

Page: 9 / 14

9
- Installation of the auxiliary handle
The auxiliary handle can be installed in 3 positions: top of the tool and both sides of the tool. The place where
to install the auxiliary handle will depend of the position where you will use the tool. Install and screw firmly the
handle with the provided wrench until it locks in place. See the operation part for install the handle according
the position of tool. Switch off the tool when you want to change the position of the auxiliary handle.
4) Operation
Before plug the tool, find the correct work position. You can turn the main handle position to 90º (left or right). To
change the position, push and hold the lock off button and turn the tool to desired position and lock it in place.
Then install the auxiliary handle (as explained above) according the position of the tool. Push and hold the same
lock off button to put the tool at its original position.
NOTE: always switch off the tool before change the position of the main handle and the auxiliary handle.
Plug the supply cord to a socket.
The ON/OFF switch has a safety switch which prevents inadvertent starting. To start the operation, push forward
the safety switch and push the ON/OFF switch. The safety switch and the ON/OFF switch must be hold together
during the operation.
To stop the operation, releases the switches button.
The tool will not operate if the safety switch is not pushed.
Rough grinding
For the best rough grinding results, hold the grinding wheel at an angle of between 30
o
and 40
o
to the work-piece
surface and guide back and forth over the work-piece in steady movements.
Cutting
When you use the right-angle grinder for cutting purposes, avoid tilting it in the cutting plane. The cutting wheel
must have a clean cutting edge. A diamond cutting wheel is best used to cut hard stone. It is prohibited to use the
machine on asbestos materials!
Never use a cutting wheel for rough grinding.
5) Replace the disk
Warning: Beware – a disc which has been used may be very hot!
1. Pull out the power plug from the mains socket.
2. Depress and hold down the spindle lock button (2) to secure the spindle
3. Turn the shaft until it locks.
4. Remove the outer flange (a) and backing flange (b) by using the two-hole spanner provided.
5. Fit the desired disc (8) on the spindle and replace the outer flange and backing flange. Release the spindle
lock.