1-800-888-2418 | www.feeneyinc.com
9
Peel back the adhesive tape protec ve layer about 6 to
12 inches, enough to begin s cking the light strip to the
underside of the channel.
Stu
ff
starter cable and connector back into post, so that light
strip starts as close to the face of the post as possible. Push
the light strip up and hold with
fi
rm pressure, allowing the
adhesive to bond to the aluminum
(See Figure 3.5)
. Con nue
peeling back the adhesive tape protec ve layer and adhering
the light strip to the railing a few feet at a me.
For systems with ligh ng installed into Series 200, 300,
350, or 450 top rail:
Con nue the en re light strip along the length of the top rail,
passing the light strip over the top of the posts and pickets.
For systems with ligh ng installed into Series 150 top rail:
Con nue the en re light strip along the length of the top
rail, passing the light strip over the intermediate pickets,
through the pre-drilled holes and RCBs in the channel of the
Series 150 top rail.
For systems with ligh ng installed into Bo om Rail:
Con nue the en re light strip along the length of the bo om
rail, passing the light strip through the pre-drilled holes and
RCBs in the channel of the bo om rail insert
(See Figure 3.6).
Corner post condi ons and newel post stair transi ons may
require addi onal connectors. See following details for
speci
fi
c installa on condi on solu ons.
Figure 3.5
Figure 3.6
Step 3 - Con nued
