1-800-888-2418 | www.feeneyinc.com
8
Measure length of strip light needed for run (face of post to
face of post). Reference ligh ng layout for approximate light
strip engths.
Cut light strip to length at nearest cut mark. Cut marks are
located approx. every 4-inches. Using scissors cut between
the 4 copper dots
(See Figure 3.1).
Determine which end of light strip will be used at star ng
post, by lining up the pos ve symbol on the light strip with
the posi ve symbol on the LED Connector. Be sure to
account for the back of the light strip (the side with the tape)
needing to face upwards. The light strip may need to be
fl
ipped end for end in order to avoid twis ng when properly
oriented
(See Figure 3.2).
Roll back the adhesive tape at the end of the light strip just
enough so that it is out of the way of where the connector
will be placed. Use the provided silicone and a
ffi
x the clear
plas c sleeve to the end of the light strip, make sure window
opening is oriented so that the copper dots are aligned in
opening
(See Figure 3.3).
The end of the light strip is now
ready to be snapped into the connector.
Snap the light strip onto the starter cable LED connector
assembly by
fi
rmly pressing the clear plas c sleeve into the
connector. The prongs of the LED connector will enter in
through the opening in the clear plas c sleeve and pierce
the light strip, contac ng the copper dots
(See Figure 3.4).
Step 3 - Install Light Strips
DC 24V
DC 24V
DC 24V
DC 24V
Figure 3.1
LED CONNECTOR
CLEAR PLASTIC SLEEVE
LIGHT STRIP
Figure 3.2
POSITIVE
SYMBOL
LED CONNECTOR
CLEAR PLASTIC SLEEVE
LIGHT STRIP
Figure 3.4
Figure 3.3
CLEAR PLASTIC SLEEVE
LIGHT STRIP
LIGHT STRIP
ADHESIVE TAPE
