FeelTech
FY2300H Series User’s Manual
23
Example
：
Output Sine Waveform
This section mainly introduces how to output a sine waveform (Frequency:
20kHz, Amplitude:2.5Vpp, DC Offset: 1.6VDC, Start Phase: 90.9°) from the [CH1]
channel.
1. Select output channel
Press CH1 to select CH1. Now all characters and border of the channel is
displayed in yellow.
2. Select the Sine
Press
WAVE
button to select Sine. Then the diagram of Sine displays on the
screen.
3. Set the frequency
Press
FREQ
button to highlight the frequency value. Press Arrow buttons to
move the cursor to the position “2” below. Then rotate the ADJ Knob to get “2”.
FREQ：00
’
020.000
’
000
’
000kHz
4. Set the Amplitude
Press
AMPL
to highlight the amplitude value. Press Arrow buttons to move
the cursor and rotate the ADJ Knob to get the figures below.
AMPL：02.50V
5. Set Offset
Press
OFFS
to highlight the offset value. Press Arrow buttons to move the
cursor and rotate the ADJ Knob to get the figures below.
OFFS：01.60V
6. Set Phase
Press
▼
button to page down and press
PHAS
button to highlight phase
value. Then Press Arrow buttons to move the cursor and rotate the ADJ Knob to
get the figures below.
PHAS：090.9°
7. Enable the output
Press
CH1
button to turn CH1 output on. The [CH1] connector outputs the
configured waveform.
8. Observe the output waveform
Connect the [CH1] connector to the oscilloscope with BNC cable. The
waveform is as shown below.
