FeelElec
40
FY8300 Series User
’
s Manual
Sy
nchronization
Press the [SYNC] button to enter the synchronization function setting
interface. Press corresponding buttons on the right to highlight or cancel selecting
status.
When the synchronization of corresponding parameters are activated, the
corresponding parameters of CH2,CH3 will vary according to variation of CH1
automatically. The parameters workable for synchronization include waveform,
frequency, amplitude, offset, and duty cycle, which can be set separately.
When
WAVE
is highlighted, the waveform of CH2,CH3 will vary according to
variation of CH1.
When
FREQ
is highlighted, the frequency of CH2,CH3 will vary according to
variation of CH1.
When
AMPL
is highlighted, the amplitude of CH2,CH3 will vary according to
variation of CH1.
When
OFFS
is highlighted, the offset of CH2,CH3 will vary according to
variation of CH1.
When
CH
is highlighted, the output state of CH2,CH3 will vary according to
variation of CH1.
When
DUTY
is highlighted, the duty cycle of CH2,CH3 will vary according to
variation of CH1.
When
RISE
is highlighted, the Rising edge time of CH2,CH3 will vary
according to variation of CH1.
When
FALL
is highlighted, the Decline edge time of CH2,CH3 will vary
according to variation of CH1.
Key points
:
The synchronization function of FY8300 series generators will be
automatically saved after each setup, and the system will still be valid after
restart. When the user can not correctly change the system parameters,
please confirm whether the step function has been opened.
