FeelElec
FY8300 Series User
’
s Manual
25
Enable Output
After configuring the parameters of the waveform selected, waveform output
could be enabled.
At start-up output of CH1,CH2and CH3 are both turned on as default. At this time
indicator lights of three channels illuminate.
The default status can be modified. Press
【
SYS
】
button and then press
【
MORE
】
button to set the output status of three channels.
For CH1 there are two status:
1) Generator is in parameter setting status and current channel selected is
CH1, then press
CH1
to switch between output ON/OFF.
2) Generator is in other working status or current channel selected is not
CH1, then press
CH1
to make CH1 as channel selected and press
CH1
again to switch between output ON/OFF.
For CH2 there are two status:
1) Generator is in parameter setting status and current channel selected is
CH2, then press
CH2
to switch between output ON/OFF.
2) Generator is in other working status or current channel selected is not
CH2, then press
CH2
to make CH2 as channel selected and press
CH2
again to switch between output ON/OFF.
For CH3 there are two status:
1) Generator is in parameter setting status and current channel selected is
CH3, then press
CH3
to switch between output ON/OFF.
2) Generator is in other working status or current channel selected is not
CH3, then press
CH3
to make CH3 as channel selected and press
CH3
again to switch between output ON/OFF.
