FY6800 Series User
’s Manual
9
—
Supports 1 s, 10 s and 100 s gate time switching.
—
Dual channel output can work with frequency meter
measurement.
VCO function can be set
— Support VCO voltage control signal generator's
frequency, amplitude, offset, duty cycle and other
parameter output functions (such as
voltage-controlled oscillator).
Used to set auxiliary function parameters and system
parameters.
—
Supports storage of 20 sets of parameters such as
frequency, amplitude, offset, and phase
—
Support Chinese and English switching
—
Support tone off/on
—
Supports multi-machine cascading
—
Supports master/slave switchover in cascaded state
—
Supports dual-channel power-on default output state
setting
4
Arrows
Press Arrow buttons to select figure which you want to edit when setting
values of each parameter.
5
ADJ Knob
When using the knob to set parameters, you can increase (clockwise)
or decrease (counterclockwise) the value at the current cursor.
6
Power
Button
The power indicator will remain on when it is turned on.
When the signal generator is turned off, the indicator light will enter the
breathing lamp state and CH1 and CH2 will stop outputting (the output will
remain at 0 volts).
7
CH1 channel
output
connector
BNC connector, nominal output impedance 50Ω.
When channel CH1 is on (the CH1 button indicator lights up), the connector
outputs the waveform in the current configuration of CH1.
8
Channel
control, OK
button
It is used to control the output of the CH1 channel and can be
switched to the CH1 parameter setting interface in any
interface.
—
Press this button, the CH1 light will turn on, and the CH1
output will turn on. At this point, the [CH1] connector outputs
the signal in the current configuration.
—
Press this button again, the indicator light goes off, and at
this point, the CH1 output is turned off.
Confirm button
—
When editing frequency parameters, press this key to
change the frequency unit.
—
When scanning the interface, press this button to start/stop
scanning.
