7
EN
ASSEMBLING
- Press the fasten button
，
hold the head and insert it into the
inlet(when inserting please pay attention the head must be slanted
as per arrow indicated on the top, see fig.2.1,then move the head
anticlockwise so that the head being fastened tightly .(fig.2.2)
- Place the snake into the head, long end first, and turn to feed the
screw slightly until it is set into the motor housing (fig. 2.3)
- Place the cutting blade onto the snake shaft with the blade facing
the front as illustrated (fig.2.4).If it is not fitted properly, meat will not
be grinded.
-
Place the desired cutting plate next to the cutting blade, fitting
protrusions in the slot (fig.2.5)
-
Support or press the center of the cutting plate with one finger
then screw the fixing ring tight with another hand (fig.2.6). Do not
over tighten.
-
Place the hopper plate on the head and fix it into position. (fig.2.7)
- Locate the unit on a firm place.
- The air passage at the bottom and the side of the motor housing
should be kept free and not blocked.
Picture 2
Summary of Contents for MR853
Page 83: ...Для нотаток ...
