Federal 204-SN8CDBLK, Installation & Operation Instructions

Page: 5 / 26

Series ’90 Cold Deli Display
Page 5
This label is located on the back of the display case.
PRE-INSTALLATION PROCEDURES
Inspection for Shipping Damage
You are responsible for filing all freight claims with the delivering truck line. Inspect all cartons
and crates for damage as soon as they arrive. If damage is noted to shipping crates or cartons or if
a shortage is found, note this on the bill of lading (all copies) prior to signing.
If damage is discovered when the case is uncrated, immediately call the delivering truck line and
follow up the call with a written report indicating concealed damage to your shipment. Ask for an
immediate inspection of your concealed damage item. Crating material must be retained to show
the inspector from the truck line.
INSTALLATION INSTRUCTIONS
Locating the Display Case
The case should be located where it is not subjected to the direct rays of the sun, heating ducts,
grills, radiator, or ceiling fans, nor should it be located near open doors or main door entrances.
Also, avoid locations where there is excessive air movement or air disturbances.
The condenser air inlet is located at the rear of the case. Do not block this inlet and do not located
the air inlet near a source of heat.
Removing Case from Shipping Skid
Move the case as near as possible to the final location before removing it from the shipping skid.
Remove the four (4) bolts that secure the case to the skid. Do not remove the shipping brackets
from the case. The brackets are intended to be used as hand grips for locating the case. Remove the
brackets when the case is in the final location
CAUTION:
Do not push against the curved glass, end glass, doors, or door frames when removing
the case from the skid or moving the case.
Case damage or glass breakage could result.