11
Cleaning the Light Heads
Installation and Service Instructions
Federal Signal
www.fedsig.com
Table 7 Flash Pattern Helper patterns
Flash Pattern #
Description
31-40
Sets Color
41
Pattern all
42
Pattern split
43
SYNC Master
44
SYNC Alt
45
COLOR Mode 5-7: Default
46
COLOR Mode 5-7: Swap Colors
47
Brightness High
48
Brightness Low
Cleaning the Light Heads
CRAZING HAZARD: Crazed, cracked, or faded domes or reflectors reduce
the light output and the effectiveness of the lighting system. Tops or
reflectors showing this type of aging must be replaced. Failure to follow
this warning may result in bodily injury or death to you or others.
CLEANING SOLUTION WARNING: The use of cleaning solutions, such as
strong detergents, solvents, and petroleum products, can cause crazing
(cracking) of the domes and reflectors. Failure to follow this warning can
damage the domes and reflectors and may result in bodily injury or death
to you or others.
Periodically cleaning the XStream
®
lenses using proper procedures and compatible
cleaners will prolong their service life. Use a mild soap and lukewarm water lightly
applied on a soft cloth to gently clean the plastic surfaces. To avoid damaging
the polycarbonate lenses, do not use heavy pressure or cleaners that are caustic,
abrasive, or petroleum-based. To remove fine scratches and haze, use a specialty
plastic cleaner/polish and a soft cloth. You can also use a high quality automotive
paste cleaner/wax that is non-abrasive.
Getting Technical Support
For technical support, please contact:
Federal Signal Corporation
Phone: 1-800-433-9132
Email: [email protected]
