B.
Antenna Bracket Installation.
The following is applicable to lightbars that
require an antenna bracket. Before installing the lightbar
on vehicle, the antenna bracket must be mounted to the
underside of lightbar.
See figure 2 and proceed as follows:
NOTE
When turning the lightbar over, use caution to
avoid damaging the lightbar domes.
1. Remove and retain the supplied nut and lock-
washer from the underside of the lightbar.
2. Position the bolt in the center of the lightbar.
Ensure that the area indicated is free from oil and dirt.
3. Remove the liner from the double stick tape
(affixed to the bracket) and mount the bracket to the light-
bar.
4. Using the previously removed hardware,
secure the bracket to the lightbar. Refer to the instructions
included with the antenna for proper installation.
REMOVE
AND
REUSE
PULL AWAY
LINER TAPE
AREA TO BE FREE
OF DIRT AND OIL
FRONT
OF
LIGHTBAR
290A5490
Figure 2.
Table 1. Electrical Connections.
BLK
Ground (-)
RED
Strobe Power, Front
WHT/RED
Strobe Power, Rear
WHT/ORG
N.C.
BLK/WHT/RED Strobe Head Select
BLU/WHT/RED Strobe Pattern Select
GRY/WHT/RED Strobe Low Power
PNK/WHT/RED Strobe Low Priority
VIO/WHT/RED Strobe Medium Priority
YEL/WHT/RED Strobe High Priority
VIO
Rear Flashing LED
WHT/VIO
Back-up Lower Level LED Flasher
WHT/GRY
N.C.
BLU
Front Flashing LED
YEL
Takedown
GRY
Man Down
GRN
Passenger Alley
ORG
Driver Alley
BRN
N.C.
WHT/BRN
N.C.
WHT/GRN
Flashing Alley/Takedown
GRN/WHT/RED N.C.
BRN/WHT/RED N.C.
WHT/BLU
N.C.
WHT/YEL
N.C.
ORG/WHT/RED N.C.
Wire Color
Vista Ricochet Powered Lightbar Function
with Man Down
C.
Function Activation.
NOTE
In the four and six head model only one strobe
power supply is provided. The red 12 AWG wire
in the control cable must be connected to 12 VDC
and fused (15-amperes) at the source for the power
supply to operate. In the eight, ten, and twelve
head models there are two strobe power supplies
provided. The red 12 AWG wire (front) and the 12
AWG white/red 12 AWG wire in the control cable
must be connected to 12 VDC and fused (15 AMP)
at the source for both power supplies to operate.
1. Low Priority Control Input.
Applying 12 VDC to the pink/white/red 22
AWG wire in the control cable will select the low priority
mode. This mode will be overridden when the medium or
high priority is selected. This input must be fused (1-am-
pere) at the source.
2. Medium Priority Control Input.
Applying 12 VDC to the violet/white/red 22
AWG wire in the control cable will select the medium
priority mode. This mode will be overridden when the high
priority mode is selected. This input must be fused (1-am-
pere) at the source.
3. High Priority Control Input.
Applying 12 VDC to the yellow/white/red 22
AWG wire in the control cable will select the high priority
-3-
