Federal Signal Corporation Viper S2 Light, Installation Instructions

Page: 2 / 4

Viper S2 for the Rear Deck of the 2013 Ford Interceptor and Taurus Sedan
2
Models 350701-06 (Single Head) and 350701-07 (Dual Head)
Table 1 Kit contents
Qty. Description Model 350701-06 Model 350701-07
1 Bracket, VS2, Single, Rear Deck 861300165 ---
1 Bracket, VS2, Dual, Rear Deck --- 861300166
1 Riser, VS2, Rear Deck 861300167 861300167
2 Screw, #6, Thread Forming 7011A120-08 7011A120-08
4 Screw, #10, Thread Forming 7011196-08 7011196-08
2 Washer, Flat, #6 7072A003 7072A003
2 Washer, Lock, #6 7075A002 7075A002
Tools Required:
Marker, drill, drill bit (either #28 or 9/64
"
), and Phillips screwdriver
NOTE: For electrical installation instructions, refer to the Installation and Maintenance Instructions packed
with the Viper S2 light heads.
Assembling the Rear Deck and Riser Brackets
To assemble the rear deck and riser brackets:
1. See Figure 1. Feed a #6 thread-forming screw through the #6 flat washer, the slots in the riser bracket, the
#6 lock washer, and into the tab of the rear deck bracket. Leave the assembly loose.
Figure 1 Rear deck bracket and riser assembly (350701-06 shown)
REAR DECK BRACKET
290A7213
#6 LOCKWASHER (2)
TAB
#6 FLAT WASHER (2)
#6 THREAD- FORMER (2)
REAR DECK RISER
2. Repeat step 1 on the other side of the bracket.
3. Tighten the assembly enough so that the riser bracket can be moved up and down with little effort, but
cannot not move on its own.