3
Q
uadra
F
lare
Warning Lights
• If a vehicle seat is temporarily removed, verify with the vehicle manu
-
facturer if the seat needs to be recalibrated for proper airbag deploy
-
ment.
• Before mounting any components, check the manual to be sure that
the component you are installing is suitable for use in that area of the
vehicle. Many components are not suitable for use in the engine com
-
partment or other extreme environmental exposure areas.
• The service life of light bulbs and strobes tubes will be shortened if the
glass portion is touched during installation. Use gloves when handling
these components. If the glass portion has been touched, clean the glass
carefully with isopropyl alcohol.
• Before drilling into a vehicle structure, be sure that both sides of the
surface are clear of anything that could be damaged. Remove all burrs
from drilled holes. To prevent electrical shorts, grommet all drilled
holes through which wiring passes. Also, ensure that the mounting
screws do not cause electrical or mechanical damage to the vehicle.
• Refer to the manual packed with the lighting system for proper electri
-
cal connections, additional precautions and information.
• Because vehicle roof construction and driving conditions vary, do not
drive a vehicle with a magnetically mounted warning light installed.
The light could fly off the vehicle causing injury or damage. Repair
of damage incurred because of ignoring this warning shall be the sole
responsibility of the user.
• To avoid denting the roof of the vehicle, place the lightbar mounting
feet as close to outer edge of the roof as possible.
• Roof damage can occur if the hook adjustment bolts are over-tightened.
On lightbar models other than Legend, tighten the hook adjustment
bolts 10 ft-lb to 11 ft-lb to prevent the lightbar from sliding front-to-
back when pulling on the mounting bracket. On all other models, tight
-
en the hook adjustment bolts 6 ft-lb to 7 ft-lb.
• Locate the light system controls so the VEHICLE and CONTROLS
can be operated safely under all driving conditions.
After Installation or Service
• After installation, test the light system to ensure that it is operating
properly.
• Test all vehicle functions, including horn operation, vehicle safety
functions and vehicle light systems, to ensure proper operation. Ensure
