MB-IDENT03 Identifier Board Installation, Maintenance, and Service Manual
5
MB-IDENT03 Identifier Board
Federal Signal
www.fedsig.com
7.
Loosely tighten that first inserted screw. Insert a second flat head machine screw into the top right
hole of the Front Fastener Strip and through the assembly into the Rear Fastener Strip and loosely
tighten the screw while the upper Rear Fastener Strip is being held in place on the opposite side of
the window guard.
8.
Being careful not to scratch the lens, add and align the lower Front Fastener Strip to the bottom front
assembly, and insert a flat-head machine screw into the left corner hole of the Front Fastener Strip
and loosely tighten the screw. See Figure 1.
9.
Insert another flat head machine screw to the right corner hole of the lower Front Fastener Strip and
through the assembly while the lower Rear Fastener Strip is being held in place on the opposite side
of the window guard. Fasten the screw into the Rear Fastener Strip and loosely tighten the screw.
See Figure 3.
Figure 3 Rear View of Message Board Mounted on Window Guard
10.
Add the remaining six flat head machine screws to the assembly and make any final alignment
position adjustments to the light before securing all ten screws. Do not use impact tools while
securing the screws to the assembly, as they may crack the lens/PC board assembly.
LIGHT HAZARD: To be an effective warning device, an emergency warning system produces
bright light that can be hazardous to your eyesight when viewed at a close range. Do not stare
directly into this lighting product at a close range, or permanent damage to your eyesight may
occur.
