Reprogramming the Light Bar
14
Integrity Light Bar
Federal Signal
www.fedsig.com
Figure 2 DIP switch settings in Serial Interface Module
J3 Connector for
Serial Cable from
Light Bar
J1 Connector For 24-Conductor Cable
Supplied With Serial Interface Module
SW2 DIP Switches (See
Table 5 on page 15)
Programming Header for Cloning Flash
Patterns from Vehicle to Vehicle (See the
instructions included with the programmer)
SW1 Button for Selecting
Flash Patterns
290A7703
Table 4 SW-2 DIP Switch Settings
SW-2
Switch
Number
Switch
Setting
Function
Up
(OFF)
Down
(ON)
1
X
FRONT/REAR LEDs cut off (turn off) when 12 Vdc is applied
their control wires (Table 5 on page 15).
1
X
FRONT/REAR LEDs enable (turn on) when 12 Vdc is
applied to their control wires
2
X
Keep in OFF position
3
3
X
X
Intersection
Scene light
4
X
SignalMaster, External controller
4
X
SignalMaster, Internal controller
5
X
Cycle forward through the selection of flash patterns
5
X
Cycle backward through the selection of flash patterns
6
X
Operation Mode
6
X
Program Mode
7
Switch for INTERSECTION operational settings (Table 6 on page 18)
8
Switch for INTERSECTION operational settings (Table 6)
Selecting External SignalMaster Control
To select External SignalMaster control:
1.
Unplug the 24-pin harness from the Serial Interface Module.
2.
Move Switch 4 on SW-2 to the up (OFF) position.
3.
Plug the 24-pin harness into the Serial Interface Module.
