Safety Messages
8
Integrity Light Bar
Federal Signal
www.fedsig.com
• The service life of light bulbs and strobes tubes will be shortened if the
glass portion is touched during installation. Use gloves when handling these
components. If the glass portion has been touched, clean the glass carefully with
isopropyl alcohol.
• When drilling into a vehicle structure, ensure that both sides of the surface are
clear of anything that could be damaged. Remove all burrs from drilled holes. To
prevent electrical shorts, grommet all drilled holes through which wiring passes.
Ensure that the mounting screws do not cause electrical or mechanical damage to
the vehicle.
• To avoid denting the roof of the vehicle, place the light bar mounting feet as close
to outer edge of the roof as possible.
• Roof damage can occur if the hook adjustment bolts are over-tightened. Torque
the adjustment bolts to 6 ft-lb to 7 ft-lb. Install keeper plates.
• Locate the light system controls so the VEHICLE and CONTROLS can be operated
safely under all driving conditions.
After Installation or Service
• After installation, test the light system to ensure that it is operating properly.
• If a seat is temporarily removed, verify with the vehicle manufacturer if the seat
needs to be recalibrated for proper airbag deployment.
• Test all vehicle functions, including horn operation, vehicle safety functions, and
vehicle light systems, to ensure proper operation. Ensure that the installation has
not affected the vehicle operation or changed any vehicle safety function or circuit.
• Scratched or dull reflectors, mirrors, or lenses will reduce the effectiveness of
the lighting system. Avoid heavy pressure and use of caustic or petroleum based
products when cleaning the lighting system. Replace any optical components that
may have been scratched or crazed during system installation.
• Do not attempt to activate or deactivate the light system control while driving in a
hazardous situation.
• Frequently inspect the light system to ensure that it is operating properly and that it
is securely attached to the vehicle.
• After installation and testing are complete, provide a copy of these instructions to
instructional staff and all operating personnel.
• Do not use a pressure washer to clean the light bar. Failure to heed this notice will
damage the light bar.
• File these instructions in a safe place and refer to them when maintaining and/or
reinstalling the product.
Failure to follow all safety precautions and instructions may result in property damage,
serious injury, or death.
