![Federal Signal Corporation Informer-IP Wall Mount B Series Description, Specifications, Installation, And Operation Manual Download Page 17](http://html1.mh-extra.com/html/federal-signal-corporation/informer-ip-wall-mount-b-series/informer-ip-wall-mount-b-series_description-specifications-installation-and-operation-manual_3879821017.webp)
17
Operations
Description, Specifications, Installation, and Operation Manual
LED
Description
TALK
The blue Talk LED flashes at a 1/10 second interval when a Live PA, Intercom
Talk session, or Text-To-Speech message is in progress. The Talk LED turns on
steady when the intercom monitor function is active. During an Intercom chat
session, the local operator must listen while the blue LED is blinking and may
talk when the LED is on steady. Audible turn-around beeps also indicate the
transitions from Talk and Listen modes. The Intercom chat session ends when
the control point Ends the Call or Resets the device.
The following indicators are for troubleshooting purposes only. These indicators are not
visible when the unit is closed.
Figure 7 Input/Output Locations
Audio/Relay
-
Input/Output Connections
The Informer-IP has two SPDT relays rated at 5 A at 30 Vdc.
The relays can be programmed to cycle on and off, or come on continuously with
programmable on time, off time, and total-time.
The relay outputs can be reset manually, or reset after a programmable number of
seconds. Relay 2 is pre-wired for use with an LP1 12 Vdc strobe.
600 ohm Audio and
Relay Outputs
(Wired for LP1 Strobe)
Alert Rear Input
RS232 Port
Ethernet
Audio Output Level Adjustment