16
Testing and Training
Informer Sensor/Radio Interface Unit (Model I-IPSIU)
Connect the I-IPSIU to the LAN using CAT5 cable. If the Wired Ethernet has PoE, no
other power connection is required.
If PoE is not available, run the supplied 9 Vdc power supply against the wall and plugged
into a 120 Vac, 60 Hz outlet. Plug the low-voltage end of the cord into the power jack
located at the rear of the I-IPSIU. Route the cord to ensure it is protected against walking
on, tripping over or pinching the cord.
Figure 6 Wall Mount Dimensions
1.71
14.18
1.70
6.06
18.98
18.28
Testing and Training
After the installation is complete, do the following:
• Test the I-IPSIU and all accessories from the control point(s) to ensure it is operating
properly.
• Ensure all users are properly trained to use the system before putting the I-IPSIU into
service.
• Verify all tone, voice, and text messages contain the correct content per the
emergency operating plan. Alerts should exceed the ambient sound levels by at least
10 dB to ensure they can be heard.
• Conduct testing on a regular basis per facility safety plans to ensure the equipment
remains in working order and operators remain familiar with the use of the
equipment.
