![background image](http://html.mh-extra.com/html/federal-signal-corporation/gl2/gl2_instruction-sheet_548422001.webp)
2562054A
REV. A 905
Printed in U.S.A.
INSTRUCTION SHEET
FOR
GRILLE LIGHT MODEL GL2
SAFETY MESSAGE TO INSTALLERS AND USERS
WARNING
People’s lives depend on your safe installa-
tion of our products. It is important to read,
understand and follow all instructions
shipped with the products. In addition, listed
below are some other important safety
instructions and precautions you should
follow:
•
To properly install this light: you must
have a good understanding of automotive
electrical procedures and systems, along
with proficiency in the installation and
use of safety warning equipment.
•
This product contains high intensity LED
devices. To prevent permanent eye
damage, DO NOT stare into the light
beam at close range.
•
DO NOT install equipment or route
wiring in the deployment path of an air
bag.
•
When drilling into a vehicle structure, be
sure that both sides of the surface are
clear of anything that could be damaged.
•
In order for the light to function prop-
erly, a separate ground connection must
be made. If practical, it should be con-
nected to the negative battery terminal.
At a minimum, it may be attached to a
solid metal body or chassis part that will
provide an effective ground path as long
as the light system is to be used.
•
Locate light control so the VEHICLE and
CONTROL can be operated safely under
all driving conditions.
•
Do not attempt to activate or deactivate
light control while driving in a hazardous
situation.
•
You should frequently inspect the light to
ensure that it is operating properly and
that it is securely attached to the vehicle.
•
File these instructions in a safe place and
refer to them when maintaining and/or
reinstalling the product.
Failure to follow all safety precautions and
instructions may result in property damage, serious
injury, or death to you or others.
A.
GENERAL.
The Model GL2 is a grille mount LED light designed to
be used in a flashing mode. Lens colors (amber, red, or blue)
are specified when ordering. The lenses are interchange-
able, and can be ordered separately.
B.
KIT CONTENTS LIST.
Qty.
Description
1
Nut, Hex, 8mm, SS
1
Washer, Flat, 8mm, SS
1
Washer, Split, 8mm, SS
1
Screw, Hex Hd., 8 x 25mm
1
Block, Pin
1
Nut, Plastic
1
Washer, Rubber
2
Bracket, Plastic
1
Screw, Allen Hd., 8 x 45mm
1
Nut, Stop, Hex, 8mm
C.
INSTALLATION.
NOTE
For maximum coverage and effectiveness, the light
assembly should be mounted in a horizontal
orientation.
1.
Metal Bracket Mounting.
To install the unit using the installed metal
bracket, proceed as follows:
a.
Determine the desired mounting location.
Scribe drill position marks on the mounting surface for the
8mm mounting bolt and for a cable routing hole (if desired).
CAUTION
Before drilling holes in ANY part of a vehicle, be
sure that both sides of the mounting surface are
clear of parts that could be damaged; such as brake
lines, fuel lines, electrical wiring or other vital
parts.
b.
Drill a mounting hole and cable routing hole
(if desired) at the previously scribed drill position marks.
c.
Secure the light assembly to the mounting
surface using the bolt, washer, lockwasher, and nut as
shown in figure 1.
2.
Plastic Bracket (Motorcycle) Mounting.
a.
Remove the metal bracket from the light
assembly.