Installation: Flat Surface (External Conduit) Mount
Model 400 Series Lights
10
9.
Using the wires extending through the conduit fitting as a
guide, determine the length of the conduit necessary for the
installation as shown in Figure 3 on page 9.
SHOCK HAZARD—DO NOT connect wires when power
is applied. Failure to follow this warning could cause
serious injury or death.
Note:
DO NOT make electrical splices within the wall/ceiling
mounting bracket.
10.
Install conduit and a condulet box (both Installer-supplied),
as indicated. Splice the leads from the light to the power
leads in the condulet box. Connect the green lead (ground)
from the light to the condulet box by the most convenient
means. Insulate all splices.
Electrical Box Mount
To install the light in an electrical box:
1. Install a 4" x 4" electrical box, conduit and wiring as
necessary (all Installer-supplied).
2.
See Figure 2 on page 8. Insert the nylon grommet in the
large center hole in the side of the light assembly main
frame casting.
3. See Figure 3 on page 9. Attach the wall/ceiling mounting
bracket to the main frame casting, using the two 1/4"-20 x
1/2" hex head screws. Make sure that all wiring from the
interior of the light passes through the large center hole in
the end of the bracket.
4. Install the adapter plate (supplied) on the 4" x 4" electrical
box, using the appropriate user-supplied hardware.
5. Start the two 10-32 x 3/4" cone point set screws in the
threaded holes in the upper and lower edges of the wall/
ceiling mounting bracket.
