U E Z G U I - 1 7 8 8 - 7 0 W V M
U s e r ’ s M a n u a l
P a g e
|
13
3/20/2024
Copyright ©2024, Future Designs, Inc
Revision 5
7)
Go back to menu
Target
and select “Connect Segger J
-
Link”
8)
Compile the application and press F5 to download and start debugging.
14.
Configuring IAR EWARM v6.30 for J-Link Flashing
The IAR tools do not require any special configuration for configuring the J-
Link tools. To update IAR’s J
-Link dll you
just need to run Segger’s J
-Link DLL Updated and select the IAR install you wish to update and click Ok.
15.
Configuring Keil uVison 4 for J-Link Flashing
To configure Keil, use the following steps.
1.
Click Flash from the Menu Bar and select Configure Flash Tools…
2.
Click the Utilities Tab.
3.
In the dropdown box for Use Target Driver for Flash Programming select the CORTEX-M/R J-LINK/J-Trace.
4.
Click the Debug tab and select the same device for Use.
