LT4935 (1:01/08)
16
260mmCRS.
30mm
460mm
FIX 4 OFF EYE
IN POSITIONS
SHOWN
TENSIONING NUT
CLAMP SCREW
Flip the slide control lever round so
that the rubber-capped end is
protruding out to the right as shown
in the left-hand picture. Check that it
slides freely up and down in the
nylon slide guides. Remove the
nylock nut with a 7mm A/F spanner
as shown
ENIGMA II SLIMLINE SLIDE
Installation Instructions
SECTION NINE
To Install the Appliance Continued
OPTIONAL CABLE FIXING SYSTEM
It is recommended that the appliance be secured to
the fireplace fascia with screws and wall plugs
supplied. The cable fixing should only be used when
fixing to 18" openings or when it is desirable not to
drill the fireplace fascia. It may not be possible to
use the cable fixing system with some pre-cast
flues.
•
Drill 4 holes in the rear of the fireplace opening in the
position shown and fix securely the 4 eye bolt with
screws and wall plugs provided.
•
Fix the fire casing back into the opening using the
cable fixing system as shown do not cut off loose ends of cable after fixing, coil and tuck
carefully into space to the sides of the burner unit.
Note
: When using the cable fixing kit with the spacer,
fix and seal the spacer to the rear of the appliance
flange with the screws and foam seal provided.
Gas Soundness Test
Turn on the gas supply to the appliance ensuring
that the restrictor elbow is fully open and check for
soundness in accordance with current codes of
practice.
CONNECTING CONTROL LEVER
Summary of Contents for ENIGMA II SLIMLINE SLIDE
Page 21: ...LT4935 1 01 08 21...
