DIGITAL MERCHANDISER
56X/77X MODELS
5
4.2 Installation of 56x Multiple Barrel Merchandisers (2-, 3-, or 4-Barrel)
Figure 4.7
Figure 4.9
Figure 4.8
Figure 4.5
Figure 4.6
Door
56X:
Top View
564HR:
Front View
Figure 4.10
3.
While holding up the door, push the gas shock socket from the door into the ball
stud on the front facing bracket. Repeat on the opposite side (
Figure 4.6
).
4.
Remove the top panel and acrylic keypad cover from the dispenser to access the
harness connections.
5.
Run the serial and LED harnesses coming out of the left side of the dispenser so
that the connections end up on the left side of the upper board. Make sure to pull
the harnesses all the way in to meet the connectors inside dispenser (
Figure 4.7
).
6.
Connect the white LED harness from the door to the J5 harness. Connect the serial
harness from the door to the Molex connector on the serial harness (
Figure 4.8
).
7.
Connect the power harness coming out of the right side of the new door to the
power extension harness coming out of the right top side of the dispenser (
Figure
4.9
).
8.
Make sure the door harnesses on the top are running through the holes on the top
panel. Ensure the harnesses are not pinched or too near the hinges (
Figure 4.10
)
Note
: For 564HR dispensers, the harnesses will connect through the front panel
instead of the top panel.
9.
Reconnect the power to the dispenser and follow start-up instructions in Section
6 of this manual.
1.
Remove the collar from each of the hinge pins on the back of the new
door using a 3/32” hex wrench. Place the collars and hex wrench
nearby so they are accessible for the next step.
2.
Slide the hinge pin from the new door into the pivot hole on the upper
brackets on the dispenser (
A
on
Figure 4.5
). Place the collar back
on each hinge pin and tighten the set screw on the shaft collars with
the hex wrench (
B
on
Figure 4.5
).
