СРС308 Processor Module
The Module Structure and Functioning
C P C 3 0 8 U s e r M a n u a l
© 2 0 1 3 F a s t w e l V e r . 0 0 1 b E
29
All contacts open - signal levels are selected at the PC/104-Plus power source.
XP13 switch is described in more detail in subsection 5.1 Selection of Buffers Power Voltage
on the PCI Bus of PC/104-Plus. Pay attention to the note:
Note
If you use a PC/104-Plus power source, the VIO voltage must be set at the
power supply module. In this case remove the jumper from the VIO (XP13)
selector switch:
all contacts should be open
.
If a PC/104-Plus power supply is not used, the jumper on the XP13 selector
switch must be put into the 1-2 or 2-3 position, see Fig. 5-1: Status of the PCI
VIO Selector (XP13) Switch Contacts.
3.4.2
Graphics Controller
The Intel Pineview microprocessor is a highly integrated solution uniting the processor core itself,
as well as the SDRAM/DDR2 controller and a 3D/2D accelerated graphics adapter.
It enables the module to efficiently process 2D/3D graphics. A built-in graphics controller permits to
connect the module directly to a standard analog monitor through the VGA connector on the board
and/or with digital TFT panels through a LVDS connector. Dual-monitor configurations are
supported in clone/extended desktop modes.
3.4.2.1
VGA CRT Interface
A 10-pin XP1 IDC10 type connector with 2 mm contact spacing is installed on the top side of the
board to connect an analog monitor to CPC308.
–
It is possible to connect VGA interface monitors having a resolution up to 1400 x 1050 (60 Hz)
(for CPC308-01 modules);
–
it is possible to connect VGA interface monitors having a resolution up to 2048 x 1536 (60 Hz)
(for CPC308-03 modules);
Fig. 3-6: VGA CRT (XP1) Connector
