Fastrax EDCH-144E/C, Installation And Operating Manual

Page: 51 / 60

5
Erase.all.stored.data.from.the.Flash-ROM.of.the.selected.dome.camera..You.will.be.asked.to.enter.Yes.or.No..If.you.intend.to.erase.all.data.then.press.the.
MenU .key,.otherwise.press.the. eSC key.to.exit.without.erasing..The.erased.data.includes.all.stored.data.(titles,.presets,.and.tours....).except.origin.offset.
The.offset.value.is.still.valid.after.all.data.is.erased..The.offset.value.can.be.zeroed.only.with.default.set.of.Offset.origin.menu..
CAUTIOn: All the data in the selected dome camera will be lost unless you download the data into a safe place. (Refer to Download / Upload data
function in Keyboard Configuration utility.) Data from the selected dome camera can be stored in the keyboard controller temporarily.
• ORIGIn OFFSeT
This.feature.is.useful.to.align.a.replaced.dome.camera.to.the.exactly.same.position.as.the.previously.installed.dome.camera.
Dome.camera’s.origin.set.and.all.data.initialize.option.do.not.override.offset.values..Only.the.default.set.option.in.this.menu.will.set.the.offset.value.to.zero..
This.can.be.used.to.avoid.ceiling.obstructions.
• DOMe ReSeT
This.feature.is.used.to.re-calibrate.the.orientation.of.a.selected.dome.camera..Origin.offset.value.is.not.affected.by.this.function...
(Offset.is.still.valid.after.origin.set)
• SYSTeM InFORMATIOn
SYSTEM.INFORMATION
CAMERA.TYPE. :.XXXXXXX
H/W.VERSION. :.V.0
ROM.VERSION. :.V.0
PROTOCOL. :.FE
BAUDRATE. :.9600BPS
EXIT.(ESC.TO.EXIT)
A.Dome.camera’s.Setup.menu.provides.essential.information.about.the.dome.camera.if.service.is.required..When.you.view.this.screen,.you.can.determine.the.
camera.type,.ROM.version..The.information.on.this.screen.cannot.be.modified.
4. Troubleshooting
If.problems.occur,.verify.the.installation.of.the.camera.with.the.instructions.in.this.manual.and.with.other.operating.equipment..Isolate.the.problem.to.the.
specific.piece.of.equipment.in.the.system.and.refer.to.the.equipment.manual.for.further.information.
Problem Possible Solution
No.video
Verify.that.power.is.connected.to.all.pieces.of.equipment.in.the.system.
Verify.that.the.power.switches.are.in.the.ON.position.
Check.the.video.connections.
Poor.video.quality
Check.that.the.BNC.connectors.are.inserted.properly.
Check.the.voltage.level.of.the.dome.camera.
Cable.for.video.is.shielded.
Dome.cameras.lose.their.positions.
Reset.the.cameras.using.the.Dome.configuration.menus.
Check.the.voltage.level.of.the.dome.camera.
Picture.is.torn.when.switching Check.Line.Lock.setting.and.adjust.phase.of.L/L.