Step 5:
Installing Electrical Harness
Connect male end of WH-1001 to female connector on FASS system.
a.
Connect red wire to ignition or to the hot side of the fuse.
c.
Route the WH-1001 through a 7/16” hole in the fire wall to a power
source in the cab. Which is hot only when the key is in the ignition posi-
tion, a good source is the ignition switch or the fuel panel.
b.
Step 6:
Review Installation & Secure
a.
Bolts and fasteners properly tightened?
b.
Electrical harness and fuel lines secured and properly tightened?
c.
Has the system been primed, refer to owners manual?
d.
Check for leaks.
e.
Start the engine
f.
Recheck all fluid and filter connections for leaks
g.
Product registration filled out and ready to be mailed or faxed.
Connect green wire to a solid clean ground, corrosion will cause issues
down the road.
d.
