Original notice – User’s manual
31
Checking the lubricant level for pneumatic
tooling
Check that the level of the lubricant reservoir
A
is almost at its maximum and fill if necessary
without exceeding the maximum level (MAX).
When using between 0°C and 5°C, add an anti-
icing additive pipette.
Control and cleaning of air filters
1. Open the air filter support and remove the filter cartridge.
2. Blow with compressed air on the outside and inside of the cartridge.
3. Replace the filter if necessary.
4. Clean and reassemble the air cleaner bracket.
WARNING
The operations described below are to be done by specialized technicians.
Changing engine oil and replacing the oil
filter
To quickly and completely drain the engine
oil it is recommended to do this when the
engine is hot (60°C maximum).
1. Place a container under the cap of the
rilsan drain connection
A
.
2. Remove the oil dipstick
B
, unscrew the
cap from the rilsan drain connection
and open the drain valve
C
.
3. Close the valve after complete draining
and tighten the cap.
4. Replace the dipstick.
5. Remove the oil filter
D
with a suitable
wrench.
6. Clean the filter holder with a dry cloth.
7. Oil the seal of the new filter.
8. Screw the new oil filter by tightening it by hand.
9. Unscrew the oil filler cap
E
.
10.
Pour approximately 1.6 liters of oil and replace the filler cap.
11.
Check that the level is almost at its maximum.
A
E
A
B
N
D
N
C
N
