21
GROWSPAN
™
GOTHIC PRO GREENHOUSES AND SYSTEMS
Revision date: 05.29.19
END PANEL INSTALLATION (continued)
Mark UV Side
X
H-Channel
Installed End Panels
with H-Channel
NOTE:
When attaching any aluminum profile,
remember to account for the areas where different
sections of profile intersect so that the profile is cut to
the proper length.
Space the screws evenly at 16" when securing the
panels. DO NOT USE WASHERS WHEN SECURING
THE H-CHANNEL TO THE END WALL FRAMING.
The H-channel can be installed before the panel is
attached to the framing or after securing the panel to
the frame.
DO NOT install profile on the bottom of the end wall
panels.
These edges are sealed with the white vent
tape.
Always remove the protective film and mark and install the
UV-protected side to the outside of the greenhouse.
Secure all polycarbonat panels as shown in the diagrams
and photos below.
GLAZING PANEL
8MM POLYCARBONATE
PANEL SPLICE "H" CHANNEL
TEK SCREW
END WALL FRAME TUBE
END WALL FRAME TUBE
TEK SCREW & NEO-BONDED WASHER
Use a Tek screw and washer to secure panel to end wall
frame. Do not crush panel when installing screws.
Diagram shows basic panel installation and fasteners used
to secure polycarbonte panels.
2. Apply white vent tape to the bottom of the lower panel
and then install the aluminum U-channel profile to the
edge of the panel adjacent to the door as shown on the
Polycarbonate Panels diagram.
3. Place the panel in position, attach it to the end wall
framing using Neo-bonded washers and the long Tek
screws.
