![background image](http://html.mh-extra.com/html/farmtek/growers-supply-115106f/growers-supply-115106f_manual_545428011.webp)
11
Revision date: 02.17.16
115107F Screen Template and Installation for 36" x 36" Kit
Complete the steps that follow to install insect screen.
1. Take bulk insect screen and cut to size using the
template shown below.
2. Use diagrams on this page to install screen.
INSTALL INSECT SCREEN — 36" x 36" Kit
Exercise caution when cutting and installing spring
wire. Wear eye protection during installation and
when handling spring wire to prevent injury.
Required parts:
• 113819 Bulk Insect Screen
• 102198 Spring Wire
Panel 1 covers four (4) sections. Secure Panel 1
to lower side channel first. Then drape panel over
frame. Secure screen to each frame square using
a single run of spring wire in each channel. Cut
wire to length. Do not stretch screen too tight.
Secure free edge of Panel 1 using same channel
and another run of spring wire. Trim panel as
desired. Leave 2" or more to reattach and stretch
panel if needed.
Secure Panel 2 to front of frame. Install spring
wires in same channels used to secure first
panel. Trim excess panel. Leave 2" or more to
reattach and stretch panel if needed.
Secure
here first.
Free Edge
End Panel 1 here
in same channel.
Panel 1
Panel 1
Panel 2
Cut two (2) panels from bulk insect screen:
• one (1) @ 4' x 14' (covers four sections)
• one (1) @ 4' x 4' (covers front section)
NOTE:
Trim panels to length
after
installation. Do not over-
stretch panels during installation. Panels should be taut.
14'
4'
4'
2' 6"
Panel 1
Panel 2