![background image](http://html.mh-extra.com/html/farmtek/112663/112663_manual_545413007.webp)
7
Revision date: 12.23.15
2
Use the photos below and the diagrams on the previous
page to assemble the frame.
Required parts:
• 110611
3-Way Corner Insert (8)
• S15P016 Square Tube @ 16" (4)
• 104779
Square Tube @ 96" (4)
• S15P052 Square Tube @ 52" (4)
Assemble the Float Bed Frame
ATTENTION:
Do not install any FA4472B Tek screw
along the top edge of the float bed frame. This surface
is reserved for the installation of the float bed liner.
• 112375
Square Tube @ 15-3/4" w/45° Cuts (22)
• FA4472B Tek Screws
• 100442
Magnetic Nut Setter
1. Install all 16" (S15P016) tubes flush with
the open end of each 110611 3-way
corner connector.
3. Install the first and last vertical support
for each end or side wall tight against
the 3-way corner connectors.
2. Install all FA4472B Tek screws into
the sides of the fittings.
Do not install
along the top frame rail.
4. Install all vertical supports for side and
end frame flush with the horizontal
tubes.
NOTE:
Do not install any Tek screws in
a location that will touch the liner once it
is installed.
5. Use the diagrams on the previous pages
to evenly space the vertical supports
along the sides.