Manual
SOFTER 15 PS | 20 PS
20
│
23
7.
MACHINE STORAGE
Long-term machine shutdown:
Store the machine under a roof if possible.
Store the machine on a flat and solid surface with sufficient load capacity.
Clean the machine before storing and conserve so that it is not damaged in any way during storage. Pay
special attention to all marked lubrication points and properly lubricate them according to the lubrication
plan.
Store the machine in the position with folded frames in the transport position. Store the machine on the axle
and the storage leg, secure the machine against spontaneous movement using scotches or another suitable
tool.
When storing, lower the machine into the lower position using hydraulics.
The machine must not lean on the discs as the working discs of the machine could be damaged.
Secure the machine against access of unauthorised persons.
8.
MACHINE LUBRICATION SCHEDULE
During machine maintenance and its lubrication, it is necessary to observe the safety regulations.
Table 8 – Locations and Intervals of the Machine Lubrication
LUBRICATION POINT
INTERVAL
LUBRICANT
Pole joint
Fig.14
- Daily, always before the work with the
machine.
- Always after the end of the season and
before storing the machine
Plastic grease
KP2P-20 Likx
dle DIN 51 502
Fig.14- Pole joint
Lubricant handling:
Protect yourselves against direct contact with oils by using gloves or protective creams. Thoroughly wash
oil spots on the skin using warm water and soap. Do not clean the skin with petrol, engine diesel fuel or
other solvents. Oil is poisonous. If you swallowed the oil, immediately seek a physician. Protect the
lubricants against children.
