Manual
FALCON SW
14
│
80
3.2.
CONNECTING THE HYDRAULICS
Connect the hydraulics only if the hydraulic circuits of the machine and the tractor (aggregate) are
without any pressure.
The hydraulic system is under great pressure. Check regularly for leakages and immediately eliminate
any visible damage to all distribution, tubes and screw joints.
When checking for and eliminating leakages, use appropriate equipment.
Use the plug (on the machine) and the socket (on the tractor) of the same type of snap coupling when
connecting the hydraulic system of the machine to the tractor. Execute the connection of the snap
coupling of the machine to the hydraulic circuits of the tractor according to Tab. 4.
Tab. 4 - Connection of the hydraulic circuits and setting up the flow of oil
Circuit
Plug
Cover colour
Oil flow direction
Flow of oil
Hydraulic motor of the fan
ISO 12,5
red
pressure tube
20 – 40 l/min
ISO 20
black
open waste
Controls of the machine
hydraulics
ISO 12,5
blue
pressure tube
50 – 60 l/min
ISO 12,5
blue
reverse tube
Drill coulter pressure /
Flexi boards
ISO 12,5
green
pressure tube
10 – 15 l/min
Micro drill
ISO 12,5
red
pressure tube
15 – 20 l/min
Three-point suspension
ISO 12,5
white
pressure tube
15 – 20 l/min
ISO 12,5
white
reverse tube
15 – 20 l/min
Hydraulic drift drive /
Hydraulic drive for wide-row
sowing
ISO 12,5
black
pressure tube
10 – 15 l/min
ISO 12,5
black
reverse tube
10 – 15 l/min
Lifting the front section
ISO 12,5
yellow
pressure tube
20 – 40 l/min
ISO 12,5
yellow
reverse tube
In order to rule out unintentional movement of the hydraulics or movement caused by third persons
(children, passengers), the controlling distributors in the tractor must be secured or blocked and the
controlling unit switched off if the machine is not used or if it is in the transport position.
The parts of the hydraulic system of the machine that are under pressure must not be disassembled.
The hydraulic oil causes serious injuries when it penetrates the skin under the high pressure. In case of
injury, immediately seek a doctor.
3.3.
CONNECTING THE ELECTRONIC UNIT
Connect the electronic unit of the machine only when the tractor is standing still and is secured against
movement and intervention by third persons.
Put the display unit to a place in the tractor where it will not obstruct the driver’s view and where it will
be in the visual field of the operator.
To connect the electronic unit, use the feeding cable that is included in the machine delivery.
The connecting cable must be connected directly to the tractor accumulator!
The connecting cable contains the required sockets for connecting the electronic unit.
Do not connect the connecting cable and the unit to any other connectors in the tractor.