Farmet DUO, Operating Manual

Page: 14 / 48

OPERATING MANUAL
OILSEED SCREW PRESS FARMET DUO
Page 14 of 48
B. TRANSPORTING THE EQUIPMENT
B.1 The vehicle intended for the transportation of the Equipment must have at
least the same bearing capacity as the weight of the transported Equipment is. The
total weight of the Equipment is stated on the nameplate.
B.2 The dimensions of the transported Equipment including the vehicle must
comply with valid acts and regulations, e.g. Decree No. 102/1995 for road
transportation.
B.3 The transported Equipment must be always attached to the vehicle so that it
cannot be released during transportation.
B.4 The carrier is liable for damages caused by the release of incorrectly or
insufficiently attached Equipment to the vehicle.
C. MANIPULATING THE EQUIPMENT BY A LIFTING DEVICE
C.1 The lifting device and binding instruments intended for manipulation with
the Equipment must have at least the same bearing capacity as the weight of the
manipulated Equipment is.
C.2 The Equipment may only be attached for manipulation in designated places
marked by stick-on labels showing a “chain”.
C.3 When attached (suspended) in designated places, it is not allowed to move in
the area of a potential reach of the manipulated Equipment.
D. WORK SAFETY LABELS
The warning safety labels are used for the Operator’s protection.
The following applies generally:

Strictly observe the warning safety labels.

All safety instructions also apply to other users.

If the aforementioned “
SAFETY LABEL
” located on the Equipment is
damaged or destroyed, THE OPERATOR MUST REPLACE IT WITH A
NEW ONE!!!

The position, appearance and exact meaning of work safety labels on the
Equipment are given in the following table (
Table 2 ) and picture ( Figure 1 ,
Figure 2 ).