10
In order to reset the NEXHO-IC fire detector, press the installation button
once. The green indicator light on the circuit board will come on. Wait until
the indicator light starts to flash and, at that point, press the button again.
The light will start to flash more slowly and will stay on for a few more
seconds. When the light goes off, the reset process is completed.
How do I reset a NEXHO-IC fire detector?
If you have installed the NEXHO-IC fire detector in a NEXHO
home-automation installation, once it has been reset, the
detector will not send warning alerts for possible detections
until you have re-configured it. To re-configure it, please refer
to the manual of the NEXHO-NT internet module or of the
NEXHO-UC central control unit and follow the steps described
in the section on how to install the corresponding detector in
the home-automation network.
