9
The NEXHO-IC fire detector allows you to perform a magnetic test to check
the proper functioning of the device.
In order to perform a test, hold a magnet to the pilot light of the device
head. At this point, all device warning light indicators should light up. After
a few seconds, the alarm will emit an audible warning signal.
If this does not happen and the device is running on battery power, replace
the battery and perform a new test.
How can I test that the NEXHO-IC fire detector is
working properly?
Please note that the fire detector must be configured
together with the NEXHO-NT internet control module or the
NEXHO-UC central control unit so that the detector is
installed in the system and can be controlled from one of
these control units. For that purpose, consult the section on
how to install fire detectors in your automation network in the
user manual of the NEXHO-NT internet module or the
NEXHO-UC central unit.
It is necessary to go through this process in order to be able to
control your thermostat modules from your NEXHO application.
Please note that if you have installed the device in a NEXHO
home-automation installation, the NEXHO-NT internet module
or the NEXHO-UC central control unit will display a warning if
the battery of one of the devices is low.
