12
1.
Press the key.
2.
Press the key ONCE, which will make the “ “ indicator position
itself in front of “Settings”.
3.
Press the key.
4.
Press the key TWICE, which will make the “ “ indicator position
itself in front of “Reset”.
5.
Press the key.
6.
The radiator will then request confirmation before resetting. Press
the and keys to select “YES” or “NO”.
7.
Press the key. If you chose “YES”, the radiator will now be reset.
If the room temperature is lower than the set temperature and the heater is not heating
up, the reason will be one of the following:
• Check if the heater has been plugged in correctly.
• The heater may be working correctly but it hasn´t been turned on for long enough for
the aluminium body to warm up. Check that the set temperature indicator is flickering
and wait for a few minutes.
• If the set temperature is not flickering but the room temperature is is above the pre-
set operating temperature, disconnect the heater, wait for a few seconds and turn it
on again.
• Perhaps you have set the heater operating output and this is not receiving permission
from any central unit to come into operation. If this is the case, you must enter MENU-
>SETTINGS->POWER and press the “+” button until it reaches 0.
• If none of the above work, contact Farho´s Technical Service at 985.514.082
WHY DOES THE HEATER NOT GIVING OFF HEAT?
HOW TO RESET A HEATER:
NOTE:
If you reset the XP heater, all of the customised programmes that you may have
stored in the memory will be deleted. If you have a Central Unit Farho or a MI-Farho, if
you reset the heater you must also re-install the automation system.
REPEATER:
This heater can work as a repeater if the signal from the internet module to the heater
is weak.
VOLTAGE:
Only if there is an internet module installed, the user can change the heater´s voltage in
order to limit the whole installation’s consumption.
