USE AND MAINTENANCE MANUAL - SECTION 1
STOCK PICKER ELEVAH 51 MOVE
– Rev. 08_2020
Page 1-3
OPERATION
General information
•
A self-propelled Stock Picker is a machine designed exclusively to carry, lift, stack or arrange
loads on shelving, controlled by an operator stationed in the driver's seat, which can be raised at
the same time as the load handling device.
•
Do not activate a faulty machine. If a fault occurs, switch-off the machine.
•
Do not suddenly move the control switches or levers from one position to the opposite one, going
via the neutral position; always bring the switch to neutral position before moving it in the position
corresponding to the next function. Activate the controls by applying slow and even pressure.
•
If there are any people on the work platform, allow personnel to operate the machine from the
ground only in the event of an emergency.
•
Completely lower the extending structure and disconnect the power supply before moving away
from the machine.
•
You are reminded to charge batteries in a well-ventilated area.
Risk of falls
•
Prior to using the machine, ensure all railings and gates are fastened in the correct position.
•
Keep both feet firmly on the floor of the cage. Do not arrange ladders, boxes, steps, planks or
similar items on the cage to increase the range of action.
•
Do not use the extension unit to climb on or off the cage.
•
Pay maximum attention when entering or exiting the cage. Ensure the extending structure is
completely lowered. Face the machine when entering or exiting the cage. Always maintain "three
contact points" with the machine, ensuring both hands and one foot or one hand and both feet
are continuously in contact with the machine when entering and exiting.
Danger of electrocution
With regard to the safety distances from live parts of power lines and electrical systems that are not
protected or not sufficiently protected to be complied with when carrying out non-electric jobs, at net
clearance deriving from the type of job, the equipment used and the materials handled, as well as
the lateral shifting of the conductors owing to the action of wind and lowering of heights due to heat
conditions, refer to the Laws regarding safety in the workplaces of the country where the machine is
operating.
For Italy, refer to Legislative Decree 81/08, annex IX “Values of rated operating voltages of electrical
machines and systems”.
