ENGLISH
ENGLISH
GB-35
GB-34
It is necessary to clean the spray arms regularly for hard
water chemicals will clog the spray arm jets and bearings.
To remove the upper spray arm, hold the nut, rotate the
arm clockwise to remove it.
To remove the lower spray arm, pull out the spray arm
upward.
Wash the arms in soapy and warm water and use a soft
brush to clean the jets. Replace them after rinsing them
thoroughly.
Open
•
After Every Wash
After every wash, turn off the water supply to the appliance and leave the door
slightly open so that moisture and odours are not trapped inside.
•
Remove the Plug
Before cleaning or performing maintenance, always remove the plug from the
socket.
•
No Solvents or Abrasive Cleaning
To clean the exterior and rubber parts of the dishwasher, do not use solvents or
abrasive cleaning products.
Only use a cloth with warm soapy water.
To remove spots or stains from the surface of the interior, use a cloth dampened
with water an a little vinegar, or a cleaning product made specifically for
dishwashers.
•
When not in Use for a LongTime
It is recommend that you run a wash cycle with the dishwasher empty and then
remove the plug from the socket, turn off the water supply and leave the door of
the appliance slightly open. This will help the door seals to last longer and prevent
odours from forming within the appliance.
•
Moving the Appliance
If the appliance must be moved, try to keep it in the vertical position. If absolutely
necessary, it can be positioned on its back.
•
Seals
One of the factors that cause odours to form in the dishwasher is food that
remains trapped in the seals. Periodic cleaning with a damp sponge will prevent
this from occurring.
Cleaning the Spray Arms
How to Keep Your Dishwasher in Shape
INSTALLATION INSTRUCTION
Attention:
The installation of the pipes and
electrical equipments should be
done by professionals.
Warning
Electrical Shock Hazard
Disconnect electrical power
before installing dishwasher.
Failure to do so can result in
death or electrical shock.
The installation position of dishwasher should be near the existing inlet and drain
hoses and power cord.
One side of the cabinet sink should be chosen to facilitate the connection of drain
hoses of the dishwasher.
Note: please check the accompanying installation accessories (hook for aesthetic
panel, screw)
Please carefully read the installation instruction.
Illustrations of cabinet dimensions and installation position of the dishwasher
Preparations should be made before moving the dishwasher to the installation place.
1.
Choose a place near the sink to facilitate the installation of inlet and drain hoses
(see figure 1).
2.
If dishwasher is installed at the corner of the cabinet, there should be some space
(illustrated in figure2) when the door is opened.
(Figure 1)
Cabinet dimensions Less than 5mm between the top of dishwasher and cabinet and
the outer door aligned to cabinet.
Installation preparation
Electrical,
drain and
water
supply line
entrances
Space between
cabinet bottom
and floor
Summary of Contents for LVFI4515PI
Page 1: ...LVFI4515PI...
