FAR LVFI4515PI, Instruction Manual

Page: 32 / 47

ENGLISH ENGLISH
GB-19 GB-18
Dishwasher Features
1.
Upper Basket
2.
Inner pipe
3.
Lower Basket
4.
Salt Container
5.
Dispenser
6.
Cup Shelf
7.
Spray arms
8.
Filter assembly
9.
Inlet pipe connector
10.
Drain pipe
11.
Adjuster
Front view Back view
PRIOR USING FOR THE FIRST TIME
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water,
which would have a detrimental or adverse effect on the operation of the appliance.
The higher the content of these minerals and salts, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
A. Water Softener
Before using your dishwasher for the first time:
A . Set the water softener
B . Add 1.5Kg dishwasher salt and then full fill the salt container with water
C . Fill the rinse aid dispenser
D . Fill in detergent
Adjusting Salt Consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1.
Open the door .Switch on the appliance;
2.
Press the Program button for more than 5 seconds to start the water softener set
model within 60seconds after the appliance was switched on (The Salt and Rinse
aid warning lights will be on periodically when it get in the set model);
3.
Press the Program button to select the proper set according to your local
environment, the sets will change in the following sequence:
H1->H2->H3->H4->H5->H6;
4.
Press the Power button to end the set up model.
Note:1
1°dH = 1.25°Clarke = 1.78°fH = 0.178mmol/l
°DH: German degree
°fH: French degree
°Clark: British degree
Note:2
The manufactory setting: H4
Contact your local water board for information on the hardness of your water supply.
WATER SOFTENER
The hardness of the water varies from place to place. If hard water is used in the
dishwasher, deposits will form on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt container specifically
designed to eliminate lime and minerals from the water.
WATER HARDNESS
Selector
Position
Salt consumption
(gram/cycle)
° dH ° fH ° Clarke mmol/I
0~5 0~9 0~6 0~0.94 H1 0
6-11 10-20 7-14 1.0-2.0 H2 9
12-17 21-30 15-21 2.1-3.0 H3 12
18-22 31-40 22-28 3.1-4.0 H4 20
23-34 41-60 29-42 4.1-6.0 H5 30
35-55 61-98 43-69 6.1-9.8 H6 60
NOTE: If your model does not have any water softener,
you may skip this section.