145
number to dial out;
Dial Fixed Length
The number entered by the user is automatically dialed out when it
reaches a fixed length
Timeout dial
The system dials automatically after timeout
Enable E.164
Please refer to e. 164 standard specification
Add dialing rules:
Picture 93 - Custom setting of dial - up rules
Table 20- Dial-up rule configuration table
Parameters
Description
Dial rule
There are two types of matching: Full Matching or Prefix Matching.
In Full matching, the entire device number is entered and then
mapped per the Dial Peer rules.
In prefix matching, only part of the number is entered followed by
T. The mapping with then take place whenever these digits are
dialed. Prefix mode supports a maximum of 30 digits.
Note: Two different special characters are used.
x -- Matches any single digit that is dialed.
[ ] -- Specifies a range of numbers to be matched. It may be a range, a list of ranges separated
by commas, or a list of digits.
Destination
Set Destination address. This is for IP direct.
Port
Set the Signal port, and the default is 5060 for SIP.
Alias
Set the Alias. This is the text to be added, replaced or deleted. It is
an optional item.
Note: There are four types of aliases.
