76
name and password are "admin". For the specific details of the operation page, please refer to page
7.6 Network Configurations
The device supports two kinds of network connection modes: wired network connection and
wireless network connection. This section describes the wired network connection. For wireless
network connection, refer to
Devices use IP network connections to provide services. Unlike traditional devices based on circuit
technology, IP devices connect with each other through the network based on IP address to
exchange data packets and data.
To enable this device, you must first correctly configure the network configuration. To configure the
network, users need to find the device function menu button [
Device Settings
] >> [
Network
] .
The default password for advanced Settings is "123".
NOTICE! If user saw a
‘WAN Disconnected' icon flashing in the middle of screen, it
means the network cable was not correctly connected to the device's network port. Please
check the cable is connected correctly to the device and to the network switch, router, or
modem.
There are two common IP configuration modes about IPv4.
Dynamic Host Configuration Protocol (DHCP) – This is the automatic configuration mode by
getting network configurations from a DHCP server. Users need not to configure any
parameters manually. All configuration parameters will be getting from DHCP server and
applied to the device. This is recommended for most users.
Static IP Configuration – This option allows user to configure each IP parameters manually,
including IP Address, Subnet Mask, Default Gateway, and DNS servers. This is usually used in
an office environment or by power users.
The device is default configured in DHCP mode.
Please see
for detailed configuration and use.
7.7 SIP Configurations
A line must be configured properly to be able to provide telephony service. The line
configuration is like a virtualized SIM card. Just like a SIM card on a mobile phone, it stores the
