79
EN
G
LI
SH
The lamp bracket complete with headlamp re-
mains connected to the electric cables.
DO NOT
TUG ON THE ELECTRIC CABLES.
To work more comfortably the headlamp
may be detached by loosening the two side
screws.
- Shift the complete lamp bracket to the side.
NOTE: handle the plastic parts with care; do not
scratch or damage them.
POSITION LIGHT BULB
Do not tug on the electric cables to take out the
lamp-holder.
-
Grasp the lamp-holder and pull it out of its seat.
-
Take out the position light bulb (1) and re-
place it with one of the same type.
DIPPED/FULL BEAM BULB
-
Do not tug on the electric cables to remove
the bulb electric connector.
-
Remove the black rubber sleeve from the
central lamp-holder.
-
Release the lamp-holder retaining spring (3)
and remove it.
-
Draw out the lamp-holder (2) from the pa-
rabola seat.
-
Press the bulb gently and turn it counter-
clockwise.
- Take out the bulb from its seat.
Once the bulb has been changed, just proceed
with the disassembly stages in the reverse order
in order to remount the optical unit.
REAR VIEW MIRRORS
The operations described below are
valid for both rear-view mirrors.
Place the vehicle on the stand and on a flat
and stable surface. Loosen the lock nut "A",
turn the mirror counterclockwise and
remove it.
During reassembly, before tightening
the nut, check that the mirror support
rod is aligned with the handlebar.
REAR VIEW MIRRORS ADJUSTMENT
To adjust the rear-view mirrors, steer onto the vehicle in
running position and rotate the mirror according to your
needs. It is also possible to adjust the inclination of the
rear-view mirror support rod. To do this, loosen the
screw "B" and move the support rod sideways. Make
the adjustment and tighten the screw "B".
Summary of Contents for Enduro 125
Page 1: ......
Page 43: ...84 NOTES...
