(3) Momentary push button mode
(4) Enter automatic identification mode. (The green LED will fast blink)
Note:
You can also use the Action Button of In-Wall Smart Switch (Dual) to activate the
automatic identification mode, as below:
1. Quick press the Action Button 4 times, which will activate the automatic identification mode
for external switch S1, you will see the blue LED fast blinks.
2. Quick press the Action Button 6 times, which will activate the automatic identification mode
for external switch S2, the green LED will fast blink.
When the In-Wall Smart Switch (Dual) enters automatic identification mode, it has 20 seconds
before timeout for detecting the manual switch.
Touch panel control.
As you can see that the In-Wall Smart Switch (Dual)’s surface has a pin port, this port is used to
connect the Touch panel. When you have already connected it to the In-Wall Smart Switch
(Dual), you will be possible to control the In-Wall Smart Switch (Dual) through the Touch panel
directly.
Monitoring Energy Consumption.
In-Wall Smart Switch (Dual) can report wattage energy usage or kWh energy usage to a Z-Wave
control point when requested. If this function is supported by the control points, the energy
consumption will be displayed in the user interface of the control points. (The specific Z-Wave
commands supporting energy monitoring are the Meter Command Class. Automatic reports are
sent to association group 1, which is setup via the Association Command Class.) Please consult
the operation manual for these control points for specific instructions on monitoring the In-Wall
Smart Switch (Dual).
Note
: The model FT140 In-Wall Switch (Dual) does not have the ability to monitor energy
consumption. The model FT132 In-Wall Smart Switch (Dual) supports the energy metering
feature and you can see the word “Smart” on its packaging box.
Security or Non-security feature of your In-Wall Smart Switch (Dual) in Z-Wave
network.
Summary of Contents for FT132
Page 1: ...In Wall Smart Switch Dual...