13
How to Operate Your Ceiling Fan
(continued)
2.
To make the fan operational, install 23A/12V battery
(included) into the hand-held remote transmitter (If not
used for long periods of time, remove the battery to
prevent damage to the transmitter). With fan power off,
arrange code switches to the desired code setting. Then,
follow the remote code setting process. Store the remote
away from excessive heat or humidity. (Figure 2)
Figure 2
Figure 3
NOTE: If you need to change the blades: turn
WKHSRZHURIIĺFKDQJHWKHEODGHVĺWXUQWKH
powe
URQĺSHUIRUPWKHFRQWUROVHWWLQJSURFHVV
again.
5HPRWH&RQWURO6HWWLQJDQG6SHHG530
6HWWLQJ3URFHVV)LJXUH
7KHIDQLVQRZUHDG\IRUQRUPDOXVH
1. After installing the unit and restoring power to
\RXUIDQSUHVVDQGKROGWKH³6(7´EXWWRQ
VHFRQGV<RXPXVWSUHVVWKH³6(7´EXWWRQ
within 60 seconds of restoring power to the fan.
2.The fan will start to run and begin the control
setting process. The fan will run in both
GLUHFWLRQVIRUDWRWDORIDSSUR[LPDWHO\PLQXW
es.
:KHQWKHIDQVWRSVDIWHUDSSUR[LPDWHO\
PLQXWHVWKHFRQWURODQGVSHHGVHWWLQJSURFHV
s
LVFRPSOHWH
4.
The remote buttons function as follows:
I = minimum speed II = low speed
III = medium low speed IV = medium speed
V = medium high speed VI = high speed
Button:
Turns the fan off.
Reverse button:
Controls fan direction.
Controls light on/off and, infinite light levels
(performed by holding down the light on/off button).
(Figure 4)
Light button:
Fan speed:
Figure 4
&RGH6ZLWFKHV
)LJXUH
“D” and “ON” dip switch:
The “ON” selection is the light dimmable selection and is to
be used with all bulbs other than CFL. The “D” selection is
the light on only (no dimming function) and is to be used
with CFL bulbs (as CFL bulbs cannot be dimmed). The
receiver provides the following protective function:
(Figure 5)
Lock position: The DC motor has a built-in safety feature
against blade obstruction against obstruction during
operation. If something obstructs the fan blades the motor
will stop operating after 30 seconds of interruption. Please
remove obstacles and reset.
Over 80W protection: When the receiver detects motor
power consumption which is greater than 80W, the
receiver power will shutdown and fan operation will cease.
Disconnect the power supply and after 5 seconds return-
power on to the fan.