10
How to Install Your Canopy Housing
2.
Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figrue 2)
Ceiling Canopy
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
NOTE: This step is applicable after the neccessary wiring is completed.
Figure 2
Canopy Screw
Cover
How to Assemble the Ceiling Fan Blades
Figure 1
x 9
x 9
FIBER WASHER
#8-32 x 8 mm
WASHER HEAD
SCREWS
HARDWARE USED:
1.
Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
With a Phillips screwdriver, tighten #8-32 x 8 mm
washer head screws and fiber washers to secure the
blade to the blade holder. (Figure 1)
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
#8-32 x 8 mm Washer
Head Screw and Fiber
Washer (3 each per blade)
BLADE
Blade Holder
Figure 2
HARDWARE USED:
x 6
1/4˝-20 x 16 mm
SCREWS
NOTE:
Periodically check blade holder hardware and
resecure if necessary.
2.
Secure the blade holders to the flywheel using the
1/4
Ý
-20 x 16 mm screws through the holes located
on the bottom of the flywheel. (Figure 2)
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
!
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
Blade Holder
Figure 1
1/4
Ý
-20 x 16 mm
Oval Head Screw
(2 per assembly)