Fanimation FPD8088, Owner'S Manual

Page: 10 / 38

10
Figure 18
Figure 19
Figure 18
Tornillos de cabeza
hueca con arandelas
de seguridad (2 por
soporte de aspas)
x 10
Aditamentos utilizados:
Tornillos Phillips de
1/4-20 x 1/2
Assembling and Mounting the Fan Blades (cont’d)
4. Attach blade holders to the bottom of the fan motor
hub using the 1/4–20 x 1/2” socket head screws
w/lockwashers. Make sure the screws with
lockwashers securing the blade holders to the fan
motor hub are tight and that the blade holders are
properly seated. (Figure 18)
NOTE: Periodically check Blade Holder hardware and re-
secure if necessary. (see Maintenance below)
▲ WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
Adapter / Switch Cup Assembly:
1. Disassemble the Adapter Switch Cup Assembly by
removing three screws. (Figure 18)
2.
Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws.
Assemble the light plate assembly
to the support
bracket using the two key slots in the socket plate
Replace the third screw and securely tighten all three
screws (Figure 19).
Housing/Switch Cup Adapter Assembly
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
3. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade arm.
With a phillips screwdriver, tighten 3/16-24 x 7.5 mm
washer head screws and fiber washers to secure the
blade to the blade arm. (Figure 17)
x 15
x 15
FIBER WASHER
3/16-24 x 7.5mm
WASHER HEAD
SCREWS
HARDWARE USED:
Blade Holder Arm
Blade
Figure 17