Fancor 50612, Service Manual

Page: 17 / 30

Section 4: Installing Accessories
03/08 17 50612 Rev. 9
Installing Ramps
Each mild steel ramp accessory comes with two integral bolt-down plates and four
anchors.
STEPS
1. Place the ramp in position, then lift and set the platform feet into the bolt-down
plate holes.
2. Drill the
two (2) 7/16” holes
using a hammer drill. Insert the anchors with the
nut and washer already on.
3. Tap the anchor into the hole, then tighten the nuts securely.
IMPORTANT TIPS
•
If two ramps are installed, then no other bolt-down plates are needed.
•
If only one ramp is installed, then a set of two bolt-down plates are necessary.
•
Only two ramps (total) may be installed on opposite sides of a scale platform.
Installing Bumper Guards
Bumper Guards help protect the platform from direct hits from forklift traffic. The
guards are slightly higher than the scale and help deflect the forks.
STEPS
1. Place the bumper guard into a position so it protects the platform from non-scale
traffic.
─ Place the bumper guard so it does not touch or interfere with the platform’s
movement.
2. Drill the
7/16”
fastening holes using a hammer drill.
3. Insert the anchors with the
nut and washer already on it
.
4. Tap the anchor into the hole.
5. Tighten the nuts securely.